MRT Performance Parts & Accessories Photos

Daihatsu

MRT custom sports exhaust parts

G200 Exhaust parts

G200 Rear 3" sports muffler, progressive springs, rear sway bar shown on hoist, no wheel fitted, close up.
Bottom half of 2 part extractors for 4 cylinder Daihatsu engine
Close up of above showing flange joint, fitted.
3 cylinder extractors as fitted to G200 CNL110
Long shot of whole engine bay of above
Close up of heat proofed, painted extractors, from top, fitted 4 cylinder 2 part extractors tuned length suitable with air conditioning MUE110
G200 engine bay with painted red rocker cover ram pod mount only visibleCNE041 & CNE042 and extractors

G100 exhaust parts

3 Cylinder turbo exhaust manifold, race type, replaces exactly. Suitable for cars with or without catalytic converters CET111 (shown) or CET110 Standard and new part shown.
Bottom half of two part hand made MRT extractors4 cylinder Daihatsu engine fitted.
Close up of above showing flanged joint, fitted.

G100 engine parts

Engine bay shot CB60 fitted to Australian model carby turbo engine.

Special cars

G102 SG special, with GTti CB80 engine fitted (not shown) Front bumper CB211 and side skirts CB210, rear wing CB213
Daihatsu GTti CB80 twin cam turbo EFI engine 990cc Engine on stand
Same motor fitted to GTti G100 Charade. Engine bay strut brace also fitted "Joes"car with blue trimmed engine parts. MRT aftermarket engine treatment.
Engine bay shot CB60 fitted to Australian model single cam turbo 3 cylinder Carby turbo factory fitted engine.
GTti rear Standard parts with small top hatch wing fitted.
GTti Engine layout Standard factory fitted parts

Feroza Engine parts

Ram pod Group A fitted to Feroza FE041 & FE041a Close up, with extractors shown below.
Larger engine bay shot of Feroza 1.6 litre engine and ram pod assembly

Feroza Exhaust parts

Rear sports muffler kit Feroza FE030 (kit) FE032 shown. Also FS030 rear DeCarbon shock kit Parts shown fitted to car.
Extractors with Thermotec heat wrap fitted Feroza FE110 Not fitted, shows stainless flex joint supplied as part of unit.

Feroza body kit parts

Bonnet scoop fitted to Feroza CNB244 NACA flush type, long shot
Bonnet scoop fitted to Feroza CNB244 NACA flush type scoop. Close up

Rally Photos

Rally car G200 Detomaso debut rally, Adelaide, B/W photo, with light pod fitted.
Rally car G200 Testing new Detomaso, 1600 Charade. LH corner with wheel off ground. Wiseman's Ferry NSW Australia.
Rally car G102 LH hair pin corner, Coffs Harbour ARC. 1995
Rally car G102 Straight 3/4 shot as above. 1995
Rally car G102 LH corner Esanda International Rally 1995
Rally car G102 & Truck Service point Detomaso Charade and Delta Truck 1995 Melbourne ARC
Rally car G200 in Tasmania Detomaso Charade end of stage, 1995 Tasmanian, ARC, in the snow!
Rally car in workshop G102 early preparation. 1994

HOME

Copyright © 1995-2007. All rights reserved.
MRT Performance - ABN 69 198 394 100
EMAIL: info@mrtrally.com.au PHONE: (02) 9767 4545